Beep; Light; Ats Fm / Ats Am; Am 10K/Fm 100K - Sangean DT-800 Manual

Settings in MENU
● BEEP – Press the SELECT button, then the TUNING up or down
button to select Beep ON or OFF during radio operation that requires
press and hold buttons to activate e.g. enter MENU, memory preset
stations etc. Press the SELECT button to confirm Beep setting.
● LIGHT – Press the SELECT button then TUNING up or down button
to select the display illumination time of 10S (seconds) -20S-30S-OFF
after last radio operation. Select OFF if you do not want the display
illuminated during radio operation to help extend battery life.
● ATS FM / ATS AM – see operation on ATS- Auto Tuning System described
above. ATS FM / ATS AM can be operated only when the radio is on.
● AM 10K – AM tuning steps vary by countries. The AM tuning steps in
Northern America and Latin America are 10 kHz / tuning steps while
other countries are 9kHz. Press the SELECT button then TUNING up
or down button to select either 10k or 9k AM tuning step. Press the
SELECT button to confirm AM tuning step setting.
● FM 100K – FM tuning step in Northern America and Latin America are
normally 200kHz and 100kHz for other countries. Following the same
procedures of selecting the AM tuning steps to select FM tuning step
to be 50kHz, 100kHz or 200kHz.
● 87 – 108 – Select FM band frequency coverage.
FM band frequency coverage is normally 87.50-108 MHz for most
countries; however for some countries like Japan and Russia, they
may have various frequency coverage.
Following the same procedures as above to cycle through and set the
required FM frequency coverage to be 87-108, 76-90, 76-108 or 64-
108 MHz.
022