Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sangean DT-140
Summary of Contents for Sangean DT-140
- Page 1 DT-140 中文 Version 1...
- Page 2 Installing the belt clip Removing the belt clip...
- Page 3 If the battery does not recharge after several attempts, it may be drained (has a low charge), please contact contact@sangean.com for repair information. However, if you do not want us to replace the battery, you will need to dispose of used batteries / device in accordance to the laws and regulations in your area.
-
Page 4: User Safety Precautions
User Safety Precautions ● Check the room temperature range is 0°C-45°C (32°-11 3°Fahrenheit) before charging the battery. ● Do not attempt to disassemble the plastic covering or any parts of the device, as the materials inside may be toxic and may damage skin and clothes. ● Do not puncture, crush, modify, throw or cause any unnecessary shock to your battery, as the battery used in this device may present a risk of fire, explosion, or chemical burn if mistreated. ● Do not leave, charge or use the battery in a car under direct sunlight, near fire or a heated source. ● Do not immerse, throw, wet the battery in water / seawater. ● Do not use or charge the battery if it appears to be abnormally hot, discoloration, deformation or abnormal conditions is detected during use, charge or storage. ● Do not leave a charging battery unattended. Keep the battery away from babies and children. -
Page 5: Volume Control
Antenna / Earphone Insert the earphone into the earphone jack. The cord connecting the earphone to the receiver acts as an antenna during FM audio reception and should be extended as much as possible to increase the sensitivity. A built-in ferrite bar antenna is provided for AM reception, it is only necessary to rotate the radio for maximum signal strength during AM listening. -
Page 6: Recalling A Preset Station
“DBB” symbol. Pressing the DBB button again will cancel the DBB function. NOTE Sangean suggests activating the DBB when using earphones. Software version / Setting tuning step The software display cannot be altered and is just for your reference. -
Page 7: Factory Reset
Factory reset If you wish to completely reset your radio to its initial state this may be performed by the following procedure. By performing a factory reset, all user entered settings will be erased. Turn off the radio. Press and hold Preset 3 button and the Band button at the same time, the “dEF” will appear and flash on the display. Continue holding down these two buttons until all the icons appear on the screen.
Need help?
Do you have a question about the DT-140 and is the answer not in the manual?
Questions and answers