Battery; Battery Removal; Battery Installation - Polaris RZR XP 1000 EPS 2019 Owner's Manual

MAINTENANCE

BATTERY

WARNING
Improperly connecting or disconnecting battery cables can result in an
explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the
battery, always connect the negative (black) cable last.
Your vehicle has a maintenance-free battery. Always keep battery terminals and
connections free of corrosion. If cleaning is necessary, remove the corrosion
with a stiff wire brush. Wash with a solution of one tablespoon baking soda and
one cup water. Rinse well with tap water and dry off with clean shop towels. Coat
the terminals with dielectric grease or petroleum jelly.

BATTERY REMOVAL

1. Remove the driver's seat (RZR) or the left rear passenger seat (RZR 4). See
the Seats section for details.
2. Disconnect the black (negative) battery cable first.
3. Disconnect the red (positive) battery cable last.
4. Remove the battery hold-down strap.
5. Lift the battery out of the vehicle.

BATTERY INSTALLATION

Using a new battery that has not been fully charged can damage the battery and
result in a shorter life. It can also hinder vehicle performance. Follow the
instructions in the Battery Charging section before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
3. Coat the terminals with dielectric grease or petroleum jelly.
4. Secure the battery hold-down strap.
5. Connect and tighten the red (positive) cable first.
6. Connect and tighten the black (negative) cable last.
7. Verify that cables are properly routed.
8. Reinstall the seat.
150