Spark Arrester - Polaris RZR XP 1000 EPS 2019 Owner's Manual

SPARK ARRESTER

• Never operate the vehicle without the spark arrestor.
• Remove any combustible materials from the area.
Failure to heed the following warnings while servicing the spark arrestor
• Never run the engine in an enclosed area. Exhaust contains poisonous
carbon monoxide gas that can cause loss of consciousness or death in a
very short time.
• Do NOT perform service on the spark arrestor while the system is HOT.
Exhaust system temperatures can reach extreme temperatures. Allow
components to cool sufficiently before proceeding.
• Do not stand behind or in front of the vehicle while purging the exhaust
system.
• Never go under the vehicle while it is inclined.
• Wear eye protection and gloves while servicing.
Periodically clean the spark arrester to remove accumulated carbon. A plugged
spark arrester will affect engine performance. Clean daily when driving in mud
and water. Replace a cracked or damaged arrester before operating.
1. Remove the arrester retaining bolt
q w
and nut
2. Remove the arrester from the end of
e
the muffler
3. Use a non-synthetic brush to clean
the arrester screen
brush may melt if components are
warm. If necessary, blow debris from
the screen with compressed air.
4. Inspect the screen for wear and
damage. Replace a worn or
damaged screen.
5. Reinstall the arrester. Torque bolt to
9-11 ft. lbs. (12-15 Nm).
could result in serious injury or death.
.
.
r
. A synthetic
WARNING
MAINTENANCE
139