Polaris RZR XP 1000 EPS 2019 Owner's Manual page 121

1. Position the vehicle on a level surface. Place the transmission in PARK.
2. Clean the area around the crankcase drain plug.
Hot oil can cause burns to skin. Do not allow hot oil to contact skin.
3. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
4. Using an oil filter wrench, turn the filter counter-clock- wise to remove it.
5. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
6. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o-ring is in good condition.
7. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn an additional 3/4 turn.
8. Reinstall the crankcase drain plug with a new sealing washer. Torque to 12 ft.
lbs. (16 Nm).
The sealing surface on the drain plug should be clean and free of burns, nicks,
9. Remove the oil fill cap and add 2.5 quarts (2.4 l) of recommended oil.
Reinstall the fill cap.
10. Start the engine and allow it to idle for 30 seconds.
11. Stop the engine. Wait 15 seconds before removing the dipstick.
12. Remove the dipstick. Wipe it dry with a clean cloth.
13. Reinstall the dipstick completely. Remove the dipstick and check the oil level.
CAUTION
NOTE
or scratches.
MAINTENANCE
119