Table of Contents
Advertisement
CAUTION - Removal of the Groover from the shipping box and mounting of the support legs should be accomplished only with the aid
of a hoist or other lifting device. To avoid possible injury DO NOT ATTEMPT TO LIFT THE MODEL 1007 ROLL GROOVER MANUALLY.
A. MODEL 1007
1. Install a support leg
tube into the receiving
socket on the under side
of the groover base.
Push the tube fully into
the recieving socket as-
suring that the angled
cut on the tube bottoms
in the receiving socket.
Tighten the retaining
bolt on the receiving
socket. Repeat for the
other three legs (
/
" wrench).
9
16
2. The Groover should be
leveled for best grooving
results. Assure level
position of the Groover
and provide a firm fixed
base location for the
Groover.
3. Position the pump to the
desired orientation for
ease of operation. Tighten
nut to lock pump in
position or if desired,
back off just slightly to
permit pump to be
oriented by operator to
most comfortable
position during groover
operation (
/
" wrench).
15
16
6
1007/3007 RGM-7.09
SECTION III - GROOVER SET-UP
CAUTION
4. With a flat screwdriver,
open the door to the
electrical storage cabinet.
Remove the power cord
and foot switch from the
cabinet mounted on the
Groover frame. Plug the
power cord into a grounded
electrical outlet that matches
the Groover. Power
requirements: 110 volt, 30
amp or optional 230 volt.
5. Remove the padlocked
lockout clip from the power
switch. Turn the power
switch to the "on" position.
6. Turn the power switch to
the "off" position when
finished grooving or when
moving the groover. Install
the lockout clip to the power
switch and padlock the
lockout clip into position.
(
/
" shank padlock).
1
4
Advertisement
Table of Contents
