▶ The device type 6213 EV / 6281 EV is designed to control, shut off ▶ Operating instructions must be available to each user. and meter neutral media up to a viscosity of 21 mm ▶...
BASIC SAFETY INSTRUCTIONS Risk of injury due to malfunction of valves with alternating current (AC). These safety instructions do not make allowance for any Sticking core causes coil to overheat, resulting in a malfunction. • contingencies and events which may arise during the installation, ▶...
• Voltage (Tolerance ± 10 %) / Current type • Coil power consumption The operating instructions and data sheets for type 6213 EV / 6281 EV (active power in W - at operating temperature) can be found on the internet at: •...
Protection class: IP65 with accordance with DIN EN 60529 / IEC Permitted medium temperature depending on coil and seal material: 60529 with cable plug, e. g. Bürkert Type 2508 Coil body Seal material Medium temperature PA/EP 4.2 Application conditions Polyamide PA 0...+90 °C Ambient temperature: max.
In accordance with the EC Declaration of conformity, the solenoid Identification number Manufacturer code valve Type 6213 EV / 6281 EV is compliant with the EC Directives (if applicable). 4.4 Standards The applied standards, which verify conformity with the EC Directives, can be found on the EC Type Examination Certificate and / or the EC Declaration of Conformity (if applicable).
INSTALLATION 5.2 Before installation Installation position: any, actuator preferably upwards. 5.1 Safety instructions Procedure: DANGER! → Check pipelines for dirt and clean. → Risk of injury from high pressure in the equipment. Install a dirt filter before the valve inlet (≤ 500 µm). ▶...
Page 8
5.4 Manual override (optional Type 6281, 5.5 Electrical connection of the cable plug Code HA 17) WARNING! To control the valve manually, the hand lever under the coil must be turned Risk of injury due to electrical shock. into the vertical position. ▶...
MAINTENANCE, TROUBLESHOOTING Note the voltage and current type as specified on the type label. 6.1 Safety instructions WARNING! Seal Risk of injury from improper maintenance. ▶ Maintenance may be carried out by authorized technicians only and max. 1 Nm with the appropriate tools. Risk of injury from unintentional activation of the system and an uncontrolled restart.
Page 10
Escaping medium. When a sticking nut is loosened, medium may escape. ▶ Do not tighten sticking nut any further. Overheating, risk of fire. Connection of the coil without pre-assembled valve will result in Core guide pipe overheating and destroy the coil. O-ring ▶...
6.3 Malfunctions SPARE PARTS If malfunctions occur, check whether: CAUTION! → the device has been installed according to the instructions, → Risk of injury and/or damage by the use of incorrect parts. the electrical and fluid connections are correct, → Incorrect accessories and unsuitable spare parts may cause injuries the device is not damaged, and damage the device and the surrounding area.
TRANSPORT, STORAGE, DISPOSAL 7.2 Overview of replacement part sets 6213 EV 6281 EV NOTE! Coil set Coil set Transport damages. SET 1 SET 1 Inadequately protected equipment may be damaged during transport. ▶ During transportation protect the device against wet and dirt in Plunger tube shock-resistant packaging.
Need help?
Do you have a question about the 6213 EV and is the answer not in the manual?
Questions and answers