NuTone ECLIPSE 2830 Manual
NuTone ECLIPSE 2830 Manual

NuTone ECLIPSE 2830 Manual

Downdraft blower system
Hide thumbs Also See for ECLIPSE 2830:

Advertisement

Quick Links

To register this product visit www.broan.com

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Do not use this unit with an additional speed control device.
7. To reduce the risk of fire, use only metal ductwork.
8. Do not install this product with the activating switch directly
behind a burner or element. Minimum distance between the
switch and the edge of the burner should be 4 inches.
9. Loose-fitting or hanging clothing should never be worn when
operating this appliance. They may be ignited by burners/
elements on cooktop.
10. Children should not be left alone or unattended in the area
where this appliance is in use.
11. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils
slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
cooking flaming foods.
3. Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the
size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
a
FOLLOWING
:
INSTALLER: Save this manual for Electrical Inspector and Homeowner to use.
HOMEOWNER: Use and Care Information on Page 4.
MODELS 2830 & 2836 ECLIPSE
DOWNDRAFT BLOWER SYSTEM
WARNING
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet,
or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS. If the flames do not go out immedi
ately, EVACUATE AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels
- a violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher, and you
already know how to operate it.
B. The fire is small and contained in the area where it
started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
a
Based on "Kitchen Firesafety Tips" published by NFPA.

CAUTION

1. For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power
unit.
3. Clean filters and grease-laden surfaces frequently.
4. Do not repair or replace any part of this appliance unless
specifically recommended in this manual. All other servicing
should be done by a qualified technician.
5. Please read specification label on product for further informa-
tion and requirements.
6. To reduce the risk of fire and electric shock, install the
downdraft only with Broan Exterior Blower Models 331H or
332H or Broan In-Line Blower Models HLB3, HLB6, HLB9, or
HLB111. Other blowers cannot be substituted. (Blowers sold
separately.)

PLANNING

This downdraft blower system is
designed to be used to exhaust
airborne contaminants when cook-
ing with a variety of gas or electric
cooktops. It can be mounted in
island, peninsula, or conventional
wall locations.
This system can be easily installed
following these basic steps:
Cut out the countertop
opening.
cabinet.
Install exterior or in-line blower
Connect the ductwork
and electrical.
Install the cooktop.
TYPICAL INSTALLATION
CHIMNEYTOP
COUNTER
COOKTOP
TOP
AIR
VENT
3-1/4" x 10"
120 VAC
DUCT CONNECTOR
GROUNDED
OUTLET

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECLIPSE 2830 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NuTone ECLIPSE 2830

  • Page 1: Read And Save These Instructions

    MODELS 2830 & 2836 ECLIPSE DOWNDRAFT BLOWER SYSTEM To register this product visit www.broan.com READ AND SAVE THESE INSTRUCTIONS WARNING WARNING 1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR PREVENT BURNS.
  • Page 2: Specifications

    PLANNING - PLAN THE DUCTWORK (continued) Note: The high level of air flow of this appliance may affect the gas flame on some types of gas cooktops. This is NORMAL and will cause no harm, but can be corrected by lowering the speed of the blower.
  • Page 3 CUT COUNTERTOP OPENING INSTALL DUCTWORK & BLOWER 1. Lay out and cut the cooktop cut-out far enough FORWARD so BEFORE CUTTING HOLE IN CABINET FOR DUCT- downdraft will fit behind it. WORK: Check for interference with floor joists, wall studs, electri- cal wiring or plumbing.
  • Page 4: Wiring Diagram

    3. Remove switch cover from right end of air vent. WIRING DIAGRAM 4. Loosen the 2 screws holding the switch bracket in place. Position switch bracket so that activating switch just comes in contact with underside of switch membrane. Tighten screws. 5.
  • Page 5 USE AND CARE - SERVICING (Continued) CLEANING WARNING: Always disconnect electric power supply before servicing unit. WARNING: Always disconnect electric power supply before cleaning unit. It may be necessary to remove the outlet assembly from the cabinet in order to service components such as the blower motor or air vent mechanism.
  • Page 6: Service Parts

    SERVICE PARTS Models 2830 & 2836 Downdraft Blower Systems KEY NO. PART NUMBER DESCRIPTION QTY. 93400038 Bushing, 7/8" 99400024 Bushing, Heyco, 1/2" 93470012 Roller 97011927 Switch Assembly, Up/Down 99360165 Knob 97009972 Lower Switch Bracket Assembly 97011293 Green Ground Wire 97010997 Wire Harness 98007642 Back-up Plate...
  • Page 7 SERVICE PARTS Models 2830 & 2836 Downdraft Blower Systems 16 17...
  • Page 8 WARRANTY BROAN-NUTONE ONE YEAR LIMITED WARRANTY Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRAN- TIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

This manual is also suitable for:

Eclipse 2836

Table of Contents