Operation; Maintenance - Pro-Lift T-6902 Operating Instructions & Parts Manual

! WARNING
• Study, understand, and follow all instructions
before operating the device.
• Do not exceed rated capacity.
• Use only on hard, level surface capable of
supporting the load.
• Center load on saddle.
• Use as an identical pair only.
• Stands are not to be used to simultaneously
support both ends of a vehicle.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
! WARNING
To avoid crushing and related injuries:
NEVER work on, under or around a load
supported only by a hydraulic jack. ALWAYS
use adequately rated jack stands.

OPERATION

Supporting a load
! WARNING: Use only on areas of the vehicle
specified by the vehicle manufacturer. Use only on
vehicles whose support points are compatible with
the saddle of these jack stands. Incompatibility may
result in structural damage to the vehicle and/or
jack stand. Structural damage to either may result
in sudden and unexpected loss of load height.
1. Adjust height by pulling up on ratchet bar.
2. Locking handle weight should secure the ratchet
bar in desired position. To confirm this, push down
on the locking handle. Ensure locking handle and
ratchet bar are secure before loading.
3. Carefully position jack stands so that load is centered
on saddle.
4. Slowly lower the vehicle onto the stands.
5. Ensure vehicle is secure before working on, around
or under. Use wheel chocks on all unlifted wheels in
both directions to prevent inadvertent movement.
Lowering load
! WARNING: Clear all tools and personnel before
lowering load.
1. Using suitable jack, raise vehicle clear of stands.
2. Release locking handle and adjust ratchet bar to
lowest position.
3. Remove stands, then lower vehicle.

MAINTENANCE

Periodically inspect both stands. Ensure all parts move
freely. Do not apply oil or grease to any portion of this
product. If rust appears, sand affected area and cover
with suitable utility paint. Please note that there are no
replacement parts applicable to this equipment. Re-
placement stands must be purchased as an identical
pair.
Storage
Store stands in upright position and in a clean, dry
area.
3