Safety And General Information; Product Description; Specifications - Pro-Lift T-6902 Operating Instructions & Parts Manual

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety, read and
understand the information contained within. The
owner and operator of this equipment shall have an
understanding of this product and safe operating
procedures before attempting to use this product.
Instructions and safety information shall be conveyed
in the operator's native language before use of this
product is authorized. If any doubt exists as to the safe
and proper use of this product as outlined in this factory
authorized manual, remove from service immediately.
Model
T-6902
T-6903
T-6906
PREPARATION
1. Before using this product, read the owner's manual
and familiarize yourself thoroughly with the product
and the hazards associated with its improper use.
2. Inspect stands before each use. Do not use if bent,
broken or cracked components are noted. Ensure
that all parts move freely.
3. Verify the product and your application are compat-
ible. If in doubt, contact Pro-Lift Customer Support
@ (888) 332-6419.
4. Install ratchet bar into frame. Ratchet portion of bar
must be aligned with ratchet pawl (stopper).
5. Move the ratchet bar to its lowest position by raising
the locking handle, releasing the ratchet pawl, and
guiding the bar downward.
6. Ratchet bar/collar lock is accomplished by bending
the press tab (Fig.1) inward using a suitable ham-
mer and punch. This will prevent inadvertent loss of
the ratchet bar.
7. Always check the vehicle owners or service manual
for location of proper lift and support points.

SPECIFICATIONS

Capacity (per pair)
2 Ton
3 Ton 7-5/8" x 6-7/8"
6 Ton
Inspect before each use. Do not use if broken, bent,
cracked, or damaged parts (including labels) are noted.
If the equipment has been or is suspected to have been
subjected to an abnormal load or shock, immediately
discontinue use until inspected by a factory authorized
repair facility (contact distributor or manufacturer for list
of authorized repair facilities). It is recommended that
an annual inspection be done by qualified personnel
and that any missing or damaged parts, decals,
warning/safety labels or signs be replaced with factory
authorized replacement parts only. Any jack stand that
appears to be damaged in any way, is worn or operates
abnormally shall be removed from service immediately.

PRODUCT DESCRIPTION

Pro-Lift Jack Stands are designed to safely support
rated capacity, partial vehicle loads consisting of one
end of a vehicle. Each comes with a ratchet/collar lock
which prevents inadvertent loss of ratchet bar. Use as
an identical pair to support one end of a vehicle only.
Base Size Min. Height
7" x 6-1/4" 10-1/8"
11-5/16"
10-3/8 x 9" 14-3/4"
Locking Handle
Press Tab
Figure 1 - Typical Jack Stand Nomenclature
2
Max. Height
16-3/8"
16-3/4"
23-5/8"
Saddle
Ratchet Bar
Ratchet Pawl
Base Frame