Procedure
1. Contact the STG assigned contact so that the system can be shut down before cables are
disconnected. When the system is shut down, the lights on the power supply units are orange.
2. Remove the power cables and network cables.
3. Slide the system out of the rack completely and place on a stable surface.
4. Remove the two small screws (1) on the left and right of the system.
Figure 9. Slicestor 2210 - top panel
5. Press the two finger tabs (2) on the top panel and slide the top panel back (3). Then lift the top panel
(4).
6. Identify the failed fan.
7. Remove the fan by pinching the Release Tab at the top of the fan and removing it.
18
Hardware Maintenance Guide
Need help?
Do you have a question about the Cloud Object Storage System and is the answer not in the manual?