Fly; Switch On/Off; Ready To Fly; Compass Calibration - AEE MACH I Quick Start Manual

A、Swith On/O
Swith On
Long press the power button until the power indicator light ashes to blue . After 15
seconds, the "beep" sound comes out. The drone is switched on successfully.
Swith O
Long press the power button until the power indicator light goes out. The drone
turns o .
B、Ready to Fly
Launch the App, click "Enter Device"
button, follow the instructions into
settings and connect Wi-Fi between the
mobile device and the drone, then back
to the homepage of App and enter
control interface.
MACH I xxxxxx,
Default SSID:
You can reset the password by click the power button 5 times after the drone is turnd on.
The default Wi-Fi Frequency is 5.8GHz. You can switch it to 2.4 GHz by clicking the power button 3
times after the drone is turned on.
C、Compass Calibration
The drone is already calibrated in factory, Before the rst ight, suggest to calibrate the
compass again; otherwise the drone may not work properly and a ect ight safety.
Frequent calibration of the compass can improve the reliability of drone.
How to calibrate: Select "Calibration - Compass Calibration" in Settings of the upper right corner of
the ight interface, you can start to calibrate referring to the prompts.
5、Fly
Take O
Click on the "Take O " button at the buttom of the screen, slide to the right
end, the drone will take o and rise to about 0.8 m altitude and hover.
Landing
During the ight, click on the "Landing" button and slide to the right end.
The drone will land in the place.
Return
During the ight in GPS mode，click the "Return" button, slide to the right
end, the drone will return to the point of departure.
password: 00000000. it can be changed in Settings.
3