Table of Contents
Advertisement
PLACING ORIGINALS
The automatic document feeder can be used to automatically scan many
originals at once. This saves you the trouble of manually feeding each original.
For originals that cannot be scanned using the automatic document feeder,
such as a book or a document with notes attached, use the document glass.
Using the automatic document feeder
When using the automatic document feeder, place the originals in the
document feeder tray.
Make sure an original has not been placed on the document glass.
Adjust the original guides
to the width of the originals.
Using the document glass
Take care that your fingers are not pinched when closing the automatic
document feeder.
After placing the original, be sure to close the automatic document feeder. If
left open, parts outside of the original will be copied black, causing
excessive use of toner.
Place the original face down.
Align the middle of the original
with the tip of the
center of the glass.
22
Place the originals face up with the edges
aligned evenly.
how many originals can be placed. The placed
originals must not be higher than this line.
mark in the
Place the original
face down.
The indicator line indicates approximately
To place a thick original such as a book,
push up the far edge of the automatic
document feeder and then close the
automatic document feeder slowly.
Do not press hard on the automatic
document feeder. This may cause failure.
Advertisement
Table of Contents
