HP 83487A User Manual page 5

W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
C A U T I O N
C A U T I O N
General Safety Considerations
This product has been designed and tested in accordance with IEC Publica-
tion 1010, Safety Requirements for Electronic Measuring Apparatus, and has
been supplied in a safe condition. The instruction documentation contains
information and warnings which must be followed by the user to ensure safe
operation and to maintain the product in a safe condition.
There are many points in the instrument which can, if contacted, cause
personal injury. Be extremely careful. Any adjustments or service
procedures that require operation of the instrument with protective
covers removed should be performed only by trained service
personnel.
If this instrument is not used as specified, the protection provided by
the equipment could be impaired. This instrument must be used in a
normal condition (in which all means for protection are intact) only.
There are many points in the system which can, if contacted, cause
personal injury. Be extremely careful. Any adjustments or service
procedures that require operation of the system with protective
covers removed should be performed only by Hewlett-Packard
personnel.
NO OPERATOR SERVICEABLE PARTS INSIDE. Refer servicing to
qualified Hewlett-Packard personnel. To prevent electrical shock, do
not remove covers.
Before this instrument is switched on, make sure its primary power circuitry
has been adapted to the voltage of the ac power source. Failure to set the ac
power input to the correct voltage could cause damage to the instrument when
the ac power cable is plugged in.
Electrostatic discharge (ESD) on or near input connectors can damage circuits
inside the instrument. Repair of damage due to misuse is not covered under
warranty. Before connecting any cable to the electrical input, momentarily
short the center and outer conductors of the cable together. Personnel should
be properly grounded, and should touch the frame of the instrument before
touching any connector.
General Safety Considerations
v