Advertisement
CONNECTING TRANSFORMERS
Note: Stop and make sure the supplied power supply is
277VAC rated with any primary voltage greater than 120.
1.
Attach Qwik Boxes to available support member. See
Qwik Box install guide.
2.
Connect power supplies to primary wiring.
3.
Install strain relief for low voltage wire.
4.
Drill 1/2" hole through the fascia. A conduit fitting can be
installed so that conduit can be used.
5.
Insert low voltage wire into the hole and connect to LED.
Fill hole with silicone sealant.
Note: Four 96" Street Wrap™ Border per 96W Power Supply.
Side by side mounting location shown below can reduce
primary and secondary wiring labor time.
Primary 100-277VAC (IN)
VERY IMPORTANT: KEEP LOW VOLTAGE CIRCUITS ELECTRICALLY SEPARATE, DO NOT CONNECT TRANSFORMERS OR LEDs FROM DIFFERENT 96" STREET WRAP
GEN 2™ TOGETHER OR CONNECT MORE THAN FOUR 96" STREET WRAP GEN 2™ TO A 96W POWER SUPPLY!
Secondary 24VDC
Low Voltage (OUT)
96"
DO NOT
CONNECT
HIGH VOLTAGE
Fascia
TO LEDs. LEDs
ARE 24VDC
ONLY!
Main
Breaker
96"
Main
Breaker
Connect Black and White
wires from Power Supplies
to 100-277 VAC
Connect Red and Black Low
Voltage Wires from
Transformers to LEDs
Power Cable Strain
Relief Fitting
24 VDC
Low
Voltage
8
Advertisement
