Advertisement
CONTENTS
Page 2 Mounting Bracket Layout
Page 3 Installing Street Wrap into Mounting Brackets
Page 4 How to Wire RGB
Page 5 Custom Cut to Fit End of Runs & Corners
Page 6 Corner Mounting Options
Page 7 Mounting on Incline or Vertically
Page 8 Connecting Transformers
COMPONENT IDENTIFICATION & REQUIRED TOOLS
MATERIALS
Aluminum Extrusion
Lens (Acrylic)
Mounting Clip
Profile Dimensions w/ Mounting Clips
Acrylic, UV and impact resistant
Aluminum
Street Wrap 1.25"W x 96"L x 2.1875"H
24V Light Tape comes pre-installed.
END CAP A-SR2C-ECYY
96W Power Supplies
PL-96-24-U (P-OH096-24-PL)
INSIDE CORNER PIECE A-SR2C-CIYY
OUTSIDE CORNER PIECE A-SR2C-COYY
LED TRACK X-C-SR2-BASE
MIDDLE CONNECTOR A-SR2C-MXYY
YY = Blue (BL), Green (GR), Red (RD), White (WH)
REQUIRED TOOLS
• 25' Measuring Tape
• Sawzall or Compound Saw
• Carpenter Pencil
• 100' Measuring Tape Framing Square
• Square -1'
• Caulk Gun
• Box Knife
• Phillips Screwdriver
• Portable Rechargable Drill
• Wire Strippers
• Wire Snips
-5/16" hexbit and unibit
• Laser Tool or Chalk Line Substitute
-Masonry bits (If brick wall)
Fasteners for the Application if Applicable
• Extension Cord
• Phillips Screwdriver
ANGLE BRACKET
MOUNTING BRACKET A-SR2-BKTS
LED TUBE X-C-SR2-ULXX
PLTC CABLE PL-LE3-PLTC-18-2
24VDC LIGHT TAPE SPECS
Color
W/Ft.
Pure White
2.75
Red
2.75
Blue
2.75
Green
2.75
*RGB
2.75
QWIK BOX™
GETTING STARTED
Following these few simple steps will ensure a successful
installation each time.
Read all instructions before starting installation.
Inspect the boxes for damage and check the parts
1.
against the supplied parts list.
Note: Report damaged parts or shortages immediately to
prevent job slowdown/stoppage to place of purchase.
Refer to the Build-A-Border document provided on our
2.
webiste at P-LED.com/street-wrap-gen-2 and confirm
job measurements.
3.
Lay out your job on paper, making note of Power
Supply placement. Power Supplies can be placed at the
end of runs or side by side to power allowable linear
footage in each direction.
Note: If job measurements do not correspond to provided drawing, call
Principal LED immediately at (325) 227-4577. Remember: No more than
four (4) 96" units per 96W Power Supply.
ELECTRICAL
Input
W/Unit
Output
22
Maximum Load
Current at Max. Load
22
22
22
22
100-277VAC
24VDC
96W
4A
W
warranty
5
P
5
L
Advertisement
