Advertisement
CUSTOM CUT TO FIT END OF RUNS & CORNERS
END OF A RUN
1.
Peel back light tape before cutting track.
2.
Measure, mark and cut lens and track to required length. Use a fine blade.
3.
Add drain holes in the center of the cut piece of lens before reinstalling the lens to the base.
4.
Reinstall light tape to desired length ensuring to silicone down the tape and using silicone to seal cuts made to light tape.
NOTE: Always test-light the Street Wrap Gen 2™ after making field cuts. Never connect AC voltage lines to LEDs on the Street Wrap Gen 2™.
VERY IMPORTANT
Insulate or remove unused wires at the end of run to prevent shorting. Do not connect wires together or to next circuit.
1
2
4
3
5
Advertisement
