Advertisement
Positioning
•
The oven must be installed under an
extraction canopy that meets
AS 1668.2.
•
To allow access to service panel and
protection of the control components,
the left hand side of the Combi oven
must have the following minimum
clearances:
Heat Source:
- 500mm clearance from another heat
source, in order to protect the oven
control components and allow access
to the service panel.
Non-Heat Source:
300mm clearance from a non-heat
source to allow access to the service
panel.
•
Failure to adhere to these clearances
will potentially void the oven warranty
or add service costs due to lack of
access.
•
Using a spirit level, ensure that the
Combi oven is level. Adjust the foot
height to level Combi oven.
•
If using a stand, level the stand by
adjusting the feet, then level the Combi
oven.
500mm
Minimum
clearance from
heat source
300mm
Minimum
clearance from
non-heat source
Page 5
Installation
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Hide quick links:
Advertisement
