Misfeed Removal - Sharp AL-2030 Operation Manual

MISFEED REMOVAL

When the misfeed (
stop because of a misfeed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed (
will remain off. For a misfeed of originals in the SPF, see "E: Misfeed in the SPF"
(p.67).
1
Open the multi-bypass tray,
and then open the side
cover.
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed (
Misfeed in the paper feed area" (p.64).
If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.66)
If paper is misfed here, proceed
to "D: Misfeed in the lower
paper feed area". (p.66)
) indicator blinks or
) indicator will blink, while the misfeed (
) indicator blinks, proceed to "A:
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.65)
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.64)
blinks in the display, the unit will
) indicator
8
63