JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason whatsoever.
Table of Contents Warranty and Service ............................2 Table of Contents ..............................3 Warning ................................. 4 Introduction ................................5 Specifications (JLH-25/50) ............................ 6 Unpacking ................................7 Contents of the Carton ............................7 Installation ................................7 ...
3. Do not use this lever hoist for other than its intended use. If used for other purposes, JET disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use.
NOTE: The above stock numbers are representative; chain is available in other lengths. Specify length when ordering. The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
Unpacking Pre-Operation Inspection Open carton and check for shipping damage. Inspecting the Load Chain Report any damage immediately to your distributor and shipping agent. Do not discard any shipping 1. A chain stop must be attached to the second- material until the Lever Hoist is assembled and to-last link on the slack end of the chain.
Operation Inspecting Hooks It is important to check top and bottom hooks for The JLH Mini Lever Hoist may be used either in proper opening and other signs of deformation or vertical position as a hoist; or in angled or damage.
Allowable Limits for Load Chain and Hooks Load Chain Hooks (Top and Bottom) Carefully inspect the entire load chain. As Replace the hook when the distance between illustrated in Figure 8, measure five consecutive indicator points – “A” in Figure 9 – is wider than the links with calipers to find the length, Compare the limits given in the table.
Return hoist to freewheel mode and continue. Pull load chain less forcibly. * Any disassembly or repair of the lever hoist should be performed by properly trained personnel. Call JET or go to www.jettools.com to find an authorized Service Center nearest you.
Parts List: JLH-25 (0.25 Ton) Parts listed under each assembly are parts that make up that assembly. Index No. Part No. Description Size 1 ....JLH25-1G ....Top Hook Assembly..................1 ............ Top Hook ....................... 1 ............ Safety Latch Kit....................1 ....
Parts List: JLH-50 (0.5 Ton) Parts listed under each assembly are parts that make up that assembly. Index No. Part No. Description Size 1 ....JLH50-1G ....Top Hook Assembly..................1 ............ Top Hook ....................... 1 ............ Safety Latch Kit....................1 ....