Table of Contents
Advertisement
10
Help and tips
Failure
The television does not
function
Poor picture quality
Shadow and reflection in the
picture.
No picture
No color.
No or defective teletext
No sound
Remote control does not
work
Picture is not readable after
turning on the TV
If your television does not work properly even though you tried the above mentioned solutions,
try turning it on and off again. If you cannot start your television even though you have applied
all noted methods, refer to the dealer or authorised service from where you purchased the
product. Never attempt to repair a faulty device yourself.
Possible cause
Is the mains lead connected to
the mains supply and the TV?
Is the main power socket
switched on?
Is the aerial cable attached?
If you are using a satellite dish, is
it well adjusted?
Aerial may be affected by
connected external devices.
It may need fine tuning.
Picture settings are not correct.
Channel setting
Aerial
Is there any damage on the
aerial cable?
Are you sure you pressed the
correct button on your remote
control?
Color intensity level is at the
lowest setting.
Broadcast system setting (if
setting choice is available)
Problem in channel
broadcasting.
Television channel (no teletext) or
aerial system.
Very weak signal
Temporary sound mute may
be on
Is the sound turned down?
Are the batteries correctly
placed?
Are batteries exhausted?
Is there any obstacle between
the remote control and
television?
Child lock is active.
29
Solution
Check the mains lead
Check if the On/Off switch is on.
Check the aerial cable.
Have the dish adjusted.
Try disconnecting one of the
devices.
Perform fine tuning.
Adjust Brightness, Contrast and
Color.
Perform automatic, manual
channel setting or fine tuning.
Check aerial cable and system
Check the aerial cable.
Press PR+ or PR- button to turn
on the TV.
Increase the color.
Select the correct broadcast
system.
Test with another channel.
Test another channel for fine
tuning and shadowy pictures
Check the aerial system.
Try pressing the mute button
Turn on the volume with Vol +
button.
Place the batteries correctly.
Replace the batteries with new
ones.
If yes, remove it.
Disable the child lock.
Advertisement
Table of Contents
