Table of Contents
Advertisement
Potential Hazards Related to VeriFast™ MicroView
The VeriFast™ MicroView system has no specific hazards related to it. However, as the
VeriFast™ MicroView is used in conjunction with other equipment such as welding equipment and
machinery, robot, air supply, etc., the user should be aware of the warnings, hazards, and
precautions related to the use of the equipment as a whole.
10
Lockout Equipment
•
Before starting to install the VeriFast™ MicroView components
on the welding equipment, ensure that the equipment is
disconnected from all sources of power and is in the lockout
state.
•
Before turning ON the equipment, make sure all components
are assembled properly.
•
Before removing the VeriFast™ MicroView from the welding
equipment, make sure the equipment is turned OFF and is in
the lockout state.
VeriFast
TM
MicroView 1.0 – User Manual – Version 1.9
- Quick Links:
- Setup Scaling
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the VeriFast MicroView 1.0 and is the answer not in the manual?