Connector Types - Basler L301k User Manual

6-Pin Micro-miniature Receptacle
The pin assignments for the 6 pin, micro-miniature receptacle used to supply power to the camera
are shown in Table 2-2.
Pin
Number
1
1, 2
3
4
2
5, 6
1
Pins 1 and 2 are tied together inside of the camera.
2
Pins 5 and 6 are tied together inside of the camera.
Table 2-2: L301
!
Figure 2-2: L301

2.1.3 Connector Types

The 26 pin connector on the camera will be a female 0.050" MDR connector as called for in the
Camera Link Specification.
The 6 pin connector on the camera is a Hirose micro-miniature locking receptacle (part # HR10A-
7R-6PB) or the equivalent. The recommended mating connector is the Hirose micro-miniature
locking plug (Part # HR10A-7P-6S). A plug of this type will be shipped with each camera. The plug
should be used to terminate the cable on the power supply for the camera.
Basler L301k
DRAFT
Signal
Direction
Name
12 V In Input
Input
DC Gnd
Pin Assignments for the 6-pin Micro-miniature Receptacle
k
Caution!
Do not reverse the polarity of the input power to the camera. Reversing the po-
larity of the input power can severely damage the camera and leave it non-op-
erational.
Pin Numbering
k
Level Function
+12 VDC Camera Power Input
Not Connected
Not Connected
Ground DC Ground
Camera Interface
2-3