Lubrication Chart; Bolt Torque Values - RHINO DM112 Operator's Manual

Location Description
1 Front IID U-joint
2 Rear IID U-joint
3 IID Shaft Slip Joints
4 Gearboxes and Cutter Bar, Fill to respective Level Check Level After Every 8 Hours
Plug w/SAE EP90 or Equivalent Gear Lube
5 Main Frame Pivot Point
6 All Sliding Sections
7 All Pivots & Linkage
PROPER TORQUE FOR FASTENERS
Because of the severe operating conditions, correct bolt torque is very important. An improperly torqued bolt
can be easily shaken loose or broken by the vibrations. When replacing bolts, always use the same grade of
bolt as used originally. Use this chart as a guide to tightening all bolts. Torque values listed are for general use
only.
NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine oil.
They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are used.
This applies to both UNF fine and UNC coarse threads.
RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL
*
DM 07-02
© 2004 Alamo Group Inc.
MAINTENANCE

Lubrication Chart

Maintenance Section 5-6
Lubrication Frequency
After Every 8 Hours of Operation
After Every 8 Hours of Operation
After Every 8 Hours of Operation
of Operation
Daily
After Every 8 Hours of Operation
After Every 8 Hours of Operation
FIGURE 18
*