How To Tell If Your Clients Support Wpa2; How To Configure Wireless Security For A Radius Server - Motorola MT7711 User Manual

How to Tell if Your Clients Support WPA2

You can check to see if all other clients that you plan to put on the network
support WPA2. You can do this by checking the manual that came with each
device or by checking the configuration software for the installed device.
Look under Security or Encryption or Setup or Advanced Features.

How to Configure Wireless Security for a RADIUS Server

If you have a Radius Server, select the WPA/WPA2 options without PSK.
To enable WPA and WPA2 without PSK, follow these steps:
1. Under 802.11n Mode Enable/Disable, select Disable from the pulldown.
2. Find the WPA-PSK Security Settings tab. If WPA-PSK is Enabled, select
Disabled from the WPA-PSK pulldown and click Save. (Note that
WPA-PSK is Disabled by default).
3. If WPA2-PSK is Enabled, select Disabled from the WPA2-PSK pulldown
and click Save. . (Note that WPA2-PSK is Enabled by default).
4. Select Enabled for WPA2. Do not click Save yet.
5. Enter the RADIUS Server Address and click Save.
6. Enter the RADIUS Port and click Save.
7. Enter the RADIUS Key and click Save.
8. If you want to enable WPA, select Enabled for WPA, and click Save.
9. If you want to enable WPA2, make sure Enabled is selected for WPA2,
and click Save.
10. If you want to disable WPA2, select Disabled for WPA2, and click Save.
11. Under Encryption, if you have enabled WPA, or WPA and WPA2, select
AES+TKIP. If you have enabled WPA2 only, select AES only.
12. Click Save.
75