Table of Contents
Advertisement
Wireless wall transmitter, 1-gang with inscription space, Wireless wall
transmitter, 3-gang with inscription space
Manual commissioning
Local Operation
6.3 Troubleshooting
After a button actuation, the status LED of the channel or scene button flashes red
slowly for 3 seconds.
Cause: battery in the wall transmitter is almost empty.
Changing the battery (see chapter Commissioning – Inserting the battery).
The receiver does not react and the status LED of the channel or scene button displays a
transmission error. Status LED flashes red quickly for 3 seconds.
Cause 1: Radio range exceeded. Structural obstacles reduce the range.
Using a radio repeater.
Cause 2: Actuator is not ready for operation.
Check the actuator and mains voltage.
Cause 3: There are radio faults, e.g. through outside radio.
Eliminate radio interference.
i The actuator causing the transmission error can be removed from the display of
transmission errors. To do this, briefly press the Prog button of the wall transmitter during
signalling. The status LED lights up red. During this time, do not press any button on the
wall transmitter. The actuator is automatically taken into account again when it transmits a
status message after radio transmission.
After a button has been pressed, the status LED flashes red quickly for 3 seconds.
Cause: Maximum permitted transmission period (statutory Duty Cycle Limit) has almost been
reached. For the function of the transmitter to continue, the polling and display of the sum status
will be switched off. As soon as sufficient transmission time is available again, the sum status
will again be polled on button actuation.
Actuate the transmitter again after a short waiting time, normally a few seconds.
Reduce the number of actuations.
Reduce the number of actuators connected to the transmitter.
6.4 Accessories
Mounting plate set
Support ring, plastic
6.5 Conformity
Gira Giersiepen GmbH & Co. KG hereby declares that the radio system type
Order No. 5331.. / 5333 ..
corresponds to the directive 2014/53/EU. You can find the full article number on the device. The
complete text of the EU Declaration of Conformity is available under the Internet address:
www.gira.de/konformitaet
6.6 Warranty
The warranty follows about the specialty store in between the legal framework as provided for
by law
Please submit or send faulty devices postage paid together with an error description to your
responsible salesperson (specialist trade/installation company/electrical specialist trade). They
will forward the devices to the Gira Service Center.
32579222
10864957
On, Off
Basic setting: On
On, Off
Basic setting: On
24.04.2017
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Blocks the device channel for
local operation.
Order No. 5339 00
Order No. 5338 00
9/10
Advertisement
Table of Contents
