Transport And Unloading; Assembly Instructions; Installation Site Requirements; Connection To The Electrical System - Igloo W200 Instruction Manual

Fig. 2 Dimensions of the appliance
80
214
695

2.TRANSPORT AND UNLOADING

The manufacturer ships the unit properly secured and packed. Be careful with glass components during transport
and loading/unloading of the unit. The appliance should be transported vertically.
The manufacturer is not responsible for the equipment that has been damaged during transportation.

3.ASSEMBLY INSTRUCTIONS

3.1.Installation site requirements

The "W200" smoking appliance is not equipped with an exhaust fan, therefore some floats by the action of gravity
through a chimney with a baffle placed in the upper part. Produced smoke should be discharged directly to the
utility that causes the induced air draught.
The room in which the smoking appliance is placed, should be subject to general fire regulations. Appliance may
be used outdoors, but it must not be exposed to precipitation and strong wind gusts. The optimal solution is ope-
ration in roofed, enclosed and airy place. Appliance must not work without supervision.

3.2. Connection to the electrical system

• Verify that the voltage and frequency in the network match those recommended by the manufacturer (see rating
plate).
• Ensure that the cross-section of the power supply cables is suitable for the power consumption of the installed
appliance.
• It is prohibited to connect the appliance via extension cables or dividers
• The appliance must be connected to a separate, properly wired electrical circuit with a plug-in socket with a
protective pin (as per PBUE)
• Check the condition of the electrical equipment of the unit
The appliance may be activated only after the effectiveness of the electric shock protection system is confir-
med based on the results of measurements performed in accordance with the applicable regulations!
12
User manual Smoking chamber W200
180
180
440
660
www.igloo.pl
en