Advertisement
NBB Controls +
Components
GmbH
General information
Standard scope of delivery
Safety information
Nameplates
Maintenance
4
– Transmitter including carrying system
– Receiver with integrated mounting holes
– Integrated connection cable or adapter cable for receiver
The order confirmation and/or delivery note is binding for the actual scope of delivery.
Even if you have already operated radio control systems, always read these operating
instructions before commissioning. Only these operating instructions include the latest
information about your NBB radio control system.
Please refer to the enclosed documents for explanations about the operating license. Always observe
the relevant work safety and accident prevention regulations. Only trained and authorized persons may
operate the NBB radio control system. The safety features installed in the NBB radio control system
must be checked regularly.
The NBB radio control system must be shut down immediately in case of failures. The transmitter
must be switched off using the EMERGENCY STOP switch or STOP button. The connection cable
at the receiver must be disconnected from the connection (terminal) of the controlled system.
The radio control system may only be repaired by NBB or specialists authorized by NBB.
Disregarding these recommendations puts you and others in danger!
NBB refuses any warranty and liability in such cases. The radio control system is used to control machines
and transmit data. In explosive atmospheres or for the control of machines for the transport of persons
it may not be used, unless specifically authorized by the manufacturer for this application. Any different
use is prohibited and releases NBB from any responsibility.
Never expose the radio control system to strong jet high pressure cleaning equipment!
The nameplates specify transmitter and receiver type, serial number, frequency range and approval
for non-EU countries. Please always advise serial number for queries.
Example:
Transmitter Type / Version:
PocketEvo
Factory No.:
999 899 4990
Frequency:
902 – 928 MHz
The NBB radio control system is maintenance-free. Nevertheless observe the following points:
– Check EMERGENCY STOP and STOP function regularly.
– Remove residues of building material.
– Disconnect receiver from power supply before welding work, to avoid the risk of damage to
the receiver electronics.
– Check regularly for worn parts.
Edition 06/17
Advertisement
