Advertisement
>
Surface Mounted Push buttons teach mode activation with pushbutton and display
To activate teach mode, the transmitter must be switched off.
1. Press and hold the "Frequency switching" key.
2. Switch the transmitter on.
3. The letters "tt" appear in the monochrome after 2 seconds.
4. Release the "Frequency switching" key.
5. Push the button all the way down as quickly as possible. If the corresponding push button number
appears in the display, the push button can be released again. Repeat step 5 for all other SMP push
buttons. It is not necessary to reactivate the teachmode.
6. Teachmode ends automatically when all SMP push buttons are activated. The transmitter vibrates
shortly.
7. Attention! The transmitter is now in working mode!
If "tt" does not appear in the display, please switch off the transmitter
and start teach mode activation from the beginning!
Push buttons to enter and store min and max values for valves could differ from the description above.
In this case a separate supplemental information sheet will be attached to the operating instructions.
Transmitter
Transmission frequency range
Data security
Data repetition rate
LF-modulation
Baud rate
Range
Operating voltage
Current consumption
RF output
Protection class
Operating ambient temperature
Weight (without battery)
Masse (L x B x H)
PocketEvo
®
See nameplate
Addressing each transmitter using a unique Binary bit code combination
Approx. 15 ms/60 ms
GFSK
9.600 Baud (Bit/sec.)
Up to 100 m (depending on environment)
2,4 V – 2 x AA 1.2 V NiMH batteries
3,0 V – 2 x 1,5 V batteries
< 100 mA bei 3 V
< 750 μW
IP 65
– 20 to + 70 °C
PocketEvo
minor / PocketEvo
minor-LCD:
®
®
PocketEvo
®
media / PocketEvo
®
media-LCD: approx. 660 g
PocketEvo
magna / PocketEvo
magna-LCD: approx. 730 g
®
®
PocketEvo
minor / PocketEvo
minor-LCD:
®
®
PocketEvo
media / PocketEvo
media-LCD: 285 x 93 x 60 mm
®
®
PocketEvo
magna / PocketEvo
magna-LCD: 321 x 93 x 60 mm
®
®
5
approx. 600 g
257 x 93 x 60 mm
2
1
4
3
Technical data
11
Advertisement
