Advertisement
NBB Controls +
Components
GmbH
Transmitter PocketEvo
SMP-Technologie – Surface Mounted Push buttons
5
1
3
10
®
>
Changing the Surface Mounted Push buttons
– Switch off the transmitter and remove the battery.
– Unscrew the threaded sleeve with the supplied special key and pull it outwards.
– Remove the SMP-button from the top. Insert the new SMP-button.
– Place the threaded sleeve over the SMP push button again and screw it tight.
Start teach mode after changing the SMP-buttons (see below).
>
Surface Mounted Push buttons teach mode activation with pushbutton
To activate teach mode, the transmitter must be switched off.
1. Press and hold the "Frequency switching" key.
2
2. Switch the transmitter on.
3. The letters "tt" appear in the monochrome after 2 seconds.
4. Release the "Frequency switching" key.
5. Push the button all the way down as quickly as possible. If the corresponding push button number
appears in the display, the push button can be released again. Repeat step 5 for all other SMP push
buttons. It is not necessary to reactivate the teachmode.
6. Teachmode ends automatically when all SMP push buttons are activated. The transmitter vibrates
shortly.
4
7. Attention! The transmitter is now in working mode!
If "tt" does not appear in the display, please switch off the transmitter
and start teach mode activation from the beginning!
Advertisement
