Diagnostic Tables - Hoshizaki KM-660MAJ-E Service Manual

I. Diagnostic Tables
1. No Ice Production
No Ice Production - Possible Cause
1. Power Supply
2. Fuse (Control Box or Power
Supply Cord)
3. Control Switch
4. Main Transformer
5. High-Pressure Switch
6. Control Transformer
(115VAC/10.5VAC)
7. Control Board
See "II.C. Control Board Check"
8. Bin Control
See "II.D.1. Bin Control Check"
9. Mode Switch
10. Water Supply
11. Inlet Water Valve
12. Float Switch
See "II.E. Float Switch Check
and Cleaning"
13. Compressor
14. Hot Gas Valve
15. Thermistor
See "II.F. Thermistor Check"
a) Off, blown fuse, or tripped breaker.
b) Not within specifications.
a) Blown.
a) In "OFF" or "PUMP" position.
b) Defective.
a) Defective.
a) Dirty condenser.
b) Fan motor not operating.
c) Refrigerant overcharged.
d) Bad contacts.
e) Refrigerant lines or components plugged.
a) Coil winding open or shorted.
a) In alarm.
b) CB yellow "BC OPEN" LED on (bin full).
c) Defective.
a) Tripped with bin filled with ice.
b) Sensor lens dirty.
c) Defective.
a) In "CLEAN" position.
b) Defective.
a) Water supply off or improper water pressure.
b) External water filters clogged.
a) Screen or orifice clogged.
b) Coil winding open.
c) Water valve open in freeze cycle.
a) Float does not move freely.
b) Defective.
a) Compressor relay/magnetic contactor contacts bad or coil winding
open.
b) Start capacitor or run capacitor defective (single phase).
c) Internal protector open.
d) Start relay contacts bad or coil winding open (single phase).
e) Compressor defective.
a) Closed in harvest cycle.
b) Open in freeze cycle.
a) Loose, disconnected, or defective.
24