Bin Control Check And Adjustment - Hoshizaki KM-660MAJ-E Service Manual

D. Bin Control Check and Adjustment
• All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• In Hoshizaki DB and DM dispenser applications, the bin control controller setting
must be adjusted to 2. For Coca-Cola Freestyle® Dispenser and other dispenser
applications, the bin control controller setting must be adjusted to 3. Increasing
the ice level on any dispenser application could lead to icemaker movement,
water leakage, or ice overflow.
• Do not block the bin control lens with top kits or the icemaker will not operate
properly.
• Failure to properly adjust the bin control setting could result in water leakage, ice
backup, and icemaker damage.
1. Bin Control Check
The bin control is factory set for use on Hoshizaki America standard ice storage bins.
If mounted on a dispenser application or if a change to the ice level in an ice storage bin
application is desired, see "II.D.2. Bin Control Adjustment."
1) Remove the front panel and base cover. See Fig. 1.
2) Move the control switch to the "OFF" position.
3) Confirm the mode switch is in the "ICE" position, then move the control switch to the
"ON" position. See Fig. 2. Turn on the power supply, and allow the icemaker to operate.
Base Cover
WARNING
NOTICE
Fig. 1
Control Switch
18
Mode Switch
Fig. 2