Automatic Power Off Function - Zephyr Z-1171-G Instruction Manual

Note: Never turn the steam control button rapidly, as the steam will accumulate rapidly in
short time which may increase the potential of the risk of explosion.
5. Insert the frothing device into the milk about two centimetres, froth milk in the way
moving the vessel round from up to down.
6. When the required purpose is reached, you can turn the steam control knob to OFF
position.
Note: Clean the steam outlet with wet sponge immediately after steam stops generating, but
care not to hurt yourself!
7. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to
taste and if desired, sprinkle the froth with a little cocoa powder.
8. Press the ON/OFF switch to the "O" position to cut the power source off. All indicators
will be off.
Note: We recommend you allowing the maker to cool down at least for 5 min before making
coffee again. Otherwise burnt odour may occur in your Espresso coffee.
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make hot beverages like
drinking chocolate, water or tea.
1. Open the top cover, remove the detachable tank and fill it with water, the water level
should not exceed the "MAX" mark in the tank. Then place the tank into the appliance
properly.
2. Replace the top cover, then connect the appliance to power supply source.
1. 3.Press the ON/OFF switch to the "—" position, the lamp in it is illuminated.
3. Make sure the coffee/steam selector is at "O" position, turn the pump control switch to the
"—" position, the pump will pump water, when there is water flowing out, close the pump
immediately. Press the coffee/steam selector to the "—" position and wait until the lamp
in coffee/steam switch is illuminated, it shows the heating is finish.
4. Remove the frothing device from the steam wand.
5. Dip the steam wand into the liquid to be heated. Turn the steam control knob in
anti-clockwise direction slowly to start making steam.
6. When the required temperature is reached, you can turn the steam control knob to the OFF
position.
7. Press the ON/OFF switch to the "O" position to cut off the power source.

AUTOMATIC POWER OFF FUNCTION

After 25 minutes of turning on the power switch, the unit will power off automatically.
Turn the power switch to OFF position if need to reactivate the appliance after powered off
automatically.
_English_