Zephyr Z-1171-G Instruction Manual page 4

position.
Note: The appliance is not equipped with jug, please use your own jug or coffee cup.
4. Connect to power source, turn the ON/OFF switch to the "—" position. The ON/OFF
lamp will be illuminated.
5. Turn the pump control switch to the "—" position, the pump will pump water. When there
is water flowing out, close the pump by pressing the pump control switch to "O". Press
the coffee/steam selector to the "
pre-heated until the inner lamp of pump control switch is illuminated, it shows the
pre-heating is finish. Press the pump control switch to "—" position again, and water will
flow out.
6. Repeat the above steps until no water is left in the tank. Clean the jug. Now the coffee
maker is ready for brewing coffee.
Note: There may be noise when the machine is pumping water for the first time. It is
normal, the appliance is releasing the air in the system. After about 20 seconds the noise
will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance
before making coffee, including the funnel, filter and cup, so that the coffee flavour cannot be
influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with water, the water level
should not exceed the "MAX" mark in the tank. Then place the tank into the appliance
properly.
2. Select the two–cup mesh, set the steel mesh into the metal funnel, make sure the tube on
the funnel aligns with the groove in the appliance. Then insert the funnel into the
appliance from the "Insert" position, and you can fix it into the coffee maker firmly by
turning it anticlockwise until it is at the "Lock" position.
3. Place a cup (your own cup) on the removable shelf.
4. Plug-in the appliance to a power supply source. Make sure the steam control knob is on
5. the OFF position.
6. Press the ON/OFF switch to "—" position, the lamp will be illuminated. Press the
coffee/steam selector in the "O" position. Press the pump control button on the "—"
position. When there is water flowing out, close the pump immediately. The purpose of
the step is to evacuate the air out of the system.
7. When the lamp in pump control switch is illuminated, you should press the pump control
switch on the "—" position again, there will be hot water flowing out. When the lamp in it
is extinguished, close the pump. The pre-heating is finished.
position and wait for a moment, the appliance is being
O"
_English_