Device Programming And Setup; Encoder Programming And Setup Via Gui Interface - Data-Tronix DT-IPTV-QAM-ASI-2H User Manual And Manual

DEVICE Programming and Setup

To setup and program the Encoder you can use the GUI interface or the LCD Front Panel
Connecting to the GUI Interface
1. Connect an Ethernet cable directly (no Cross Over cable required) to the Web Management Port
on the rear panel of the encoder or connect the Ethernet cable to an Ethernet switch. Connect an
Ethernet Cable to your PC.
2. Using a Windows-based PC Select Windows Icon
3. Go to My Computer
4. Select Network
5. Allow UPnP to locate and list the device(s) in the right panel (Windows XP or prior)
6. Right Click and Select "View device Webpage".
Note: To setup the encoder using the Front Panel LCD see "Modulator Configuration via
Front Panel LCD".

Encoder Programming and Setup via GUI Interface:

After connecting the device to the "Web Management" port located on the rear of the device and locating
the device via the 'Network' tool in 'My Computer'
Step 1:
Right Click and Select "View device Webpage"
:
9
DT-IPTV-QAM-ASI-2H | Manual V1.0 | 01152019