Asi Output; Eas - Data-Tronix DT-IPTV-QAM-ASI-2H User Manual And Manual

ASI Output

DHCP – Use the Scroll Up/Down button to select DHCP. Press the OK button to enter
the DHCP menu. Use the Scroll Up/Down button to Enable/Disable. Press the OK button
to set.
IP Address – Use the Scroll Up/Down button to select IP Address. Press the OK button to
enter the IP Address menu. Use the Scroll Up/Down button to enter the IP Address. Use the
Scroll Up/Down menu to select the desired IP Address then press the OK button to set.
Repeat the process until the IP Address is completed. Press the OK button to set. Note: If
DHCP is enabled you will not be able to set an IP address. Select DHCP disabled if Static
IP Address required.
Subnet Mask – Use the Scroll Up/Down button to select Subnet Mask. Press the OK
button to enter the Subnet Mask menu. Use the Scroll Up/Down button to enter the Subnet
Mask. Use the Scroll Up/Down menu to select the first number of the desired Subnet Mask
then press the OK button to set. Repeat the process until the Subnet Mask is completed.
Press the OK button to set.
Gateway Address – Use the Scroll Up/Down button to select Gateway Address. Press the
OK button to enter the Gateway Address menu. Use the Scroll Up/Down button to enter
the Gateway Address. Use the Scroll Up/Down menu to select the first number of the
desired Gateway Address then press the OK button to set. Repeat the process until the
Gateway Address is completed. Press the OK button to set.
Back to Main- Select Back to Main to escape the Web Management Network Setup
Menu.
ASI Output
This device may come equipped with an ASI combined output. Connect a BNC cable to the ASI output
connector (75 Ω ) and to your Broadcast capable device.

EAS

This device may be equipped EAS Terminals/connections and CVBS (Video Input) and L/R audio input
connections on the rear panel.
If applicable, connect your EAS Alert Device System outputs to the Encoder.
If the encoder receives the proper Event signal from your EAS device, the normal input audio/video
would be replaced by the audio and video from the EAS system device. Once the encoder has received
the proper signal from your EAS device the normal input video and audio would return to a normal
operating mode.
****THIS DEVICE IS NOT AN EAS RECEIVER****
Note: It is the responsibility of the Installer/User to properly connect, verify, and test
the EAS functionality of this device with the EAS receiver.
27
DT-IPTV-QAM-ASI-2H | Manual V1.0 | 01152019