Fagor 10iE Installation & Operation Manual page 29

Axis assigned to each output. PAR30 corresponds to O1 (home) and
PAR30 to 35
PAR35 to O6 (end).
0.- Output not active.
1. Output controlled by X axis.
2. Output controlled by Y axis.
Position where each output O1 through O6 is activated. PAR40 for O1,
PAR40 to 45
PAR45 for O6.
PAR53
Select the number of decimals to be displayed.
Possible values:0.0 to 6.6 .
The first digit corresponds to the number of decimals to be displayed in mm
and the second digit to the number of decimals in inches.
When selecting a "0" value or a value greater than the number of decimals of
PAR01 it will display the factory set number of decimals.
It has no effect on rotary axes.
Note:
PAR65
It enables various functions of the dro.
Digit
1= To enter the tool length.
8
1= To enter the tool diameter.
7
1= To compensate for tool radius.
6
1= To directly access parameter PAR05.
5
Not being used at this time. It must be set to "0"
4
Not being used at this time.
3
It enables this key (HOLD).
2
It enables this key.
1
(Soft: 01.xx) - 10iE-20iE - Installation/Operation - DRO installation - (29/35)