Fagor 10iE Installation & Operation Manual page 25

Detect feedback speed alarm wh en exceeding 200Khz (60m/ min with a
1
resolution of 1µm). Not applicable to a rotary axis.
Possible values: 0 (alarms off) and "1" (alarms on).
Factory-set (default) values: 0
Feedback and feedrate alarms are shown with (. . . . . . . .) at the display.
The speed alarm is cleared by pressing this key.
Linear compensation of a machine axis. Independent for each linear axis.
PAR09
Numeric value within ±99.999 millimeters per meter.
Factory setting: 0.
Even when selecting the display in inches, this value MUST ALWAYS BE IN
Notes:
MILLIMETERS.
When a rotary axis, the setting of this parameter will be ignored.
Offset of the reference point with respect to the reference zero of the scale,
PAR10
independent for each axis.
Usually, the machine reference zero (reference mark of the linear encoder)
does not coincide with the absolute zero to be used.
Therefore, when using standard Io's, this para meter must be assig ned the
value of the distance from the mach ine zero point to the feedback reference
point.
Numeric value in resolution units for each axis.
Factory setting: 0.
This value will be in mm or inches depending on whether the INCH LED is off
or on.
PAR11
Personalize.
Digit
Not being used. Must be set to "0".
8
Operate always in mm.
7
Operate always in inches.
6
Do not display "Fagor DRO" on power-up.
5
If =0, normal zero setting and coordinate presetting (factory set)
4
If =1, quick zeroing of the position value displayed on each axis.
If =1, allow the selection of the work plane for bolt-hole drilling
3
Not being used; it must be set to "0".
2
(Soft: 01.xx) - 10iE-20iE - Installation/Operation - DRO installation - (25/35)
1 inch = 25.4 mm