General Technical Characteristics - Fagor 10iE Installation & Operation Manual

UL seal
CE seal (see
"CE seal" on page

3.3 General technical characteristics

In order to comply with UL standards, this unit must be connected in the final
application using a listed detachable co rd set (BLEZ) with a molde d three-
prong plug and a suitable fitting to be connected to the equipment, rated
minimum 300 V AC. The cord type sh all be SO, SJO or STO. Su itable Strain
Relief means must be provided in the cord set to assure the connection of the
plug and the fitting.
30)
WARNING
Before handling the connectors (mains, feedback, etc.) make sure that the
unit is not under power.
It is NOT enough to turn the display off by using the [on/off] key at the
keyboard
• Universal Power Supply between 100V AC and 240V AC ±1 0% at Mains
frequency between 45 Hz and 400 Hz. Between 120Vdc and 300 Vdc
• It withstands power outages of up to 20 milliseconds.
• 10-year memory backup of installation parameters when the unit is off.
• The operating temperature inside the DRO enclosure must be between 5º C
and 45º C (41ºF and 113ºF).
• The storage temperature inside the DRO enclosure must be -25º C and
+70º C (-13º F and 158º F).
• Maximum relative humidity: 95% non condensing at 45ºC (113ºF).
• Front Panel Sealing: IP54
except for built-in models in which case is: IP20.
(Soft: 01.xx) - 10iE-20iE - Installation/Operation - DRO installation - (15/35)
(DIN 40050), Rear panel: IP4X (DIN40050 )