Cleaning The Pre-Filter - Philips AC5659 User Manual

Cleaning the pre-filter

Clean the pre-filter when F0 is displayed
on the screen and the pre-filter cleaning
indicator is on (fig.}).
1
Switch off the air purifier and
unplug from the wall outlet.
2
Pull the top part of the side panel
to remove it from the air purifier
(fig.c).
3
Press the two clips down (1) and
pull the pre-filter towards you (2)
(fig.d).
4
If the pre-filter is very dirty, use a
soft brush to brush away the dust.
Then wash the pre-filter under
running tap water (fig.~).
5
Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
6
Put the pre-filter back into the air
purifier (fig.h).
Note
• To optimize the lifetime of the pre-
filter, make sure it air dries completely
after cleaning.
• Wash your hands after handling the
filter.
• Make sure the side with the two clips
is pointing towards you, and that all
hooks of the pre-filter are properly
attached to the air purifier.
7
To reattach the front panel, press
the top part of the panel onto the
top of the air purifier (1). Then,
gently push the panel against the
body of the air purifier (2) (fig.i).
8
Put the plug of the air purifier in the
wall outlet.
9
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time.
10
Wash your hands thoroughly after
installing filters.
EN 15