Start The Programme; Childlock; Adding Laundry - Bosch WAT Series Instruction Manual And Installation Instructions

Start the programme

Press the A button. The indicator lamp
lights up and the program starts.
The display panel shows the Ready in
time while the program is running or the
program duration and the program
progress symbols once the wash cycle
has started.
Display panel ~ Page 25
Note: Foam detection
If the Å symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.

Childlock

(E 3 sec., E 3 δευτ.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock once the
program has started.
To activate/deactivate, press and hold
the Spin speed and Finished in-time
buttons at the same time for approx.
3 seconds.The E symbol will appear on
the display panel.
E lit up: The childproof lock is
■
active.
E flashing: The childproof lock is
■
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol will light up again.
Operating the appliance
Do not turn the program
Note:
selector beyond the "off" position,
otherwise the program will stop.
The childproof lock remains
Note:
active after the program has ended and
the appliance is switched off. You must
deactivate the childproof lock whenever
you want to start a new program.

Adding laundry

Once the program has been started,
you can add more laundry or remove
laundry as required.
Press the A button to do this.
The A button indicator light will flash
and the machine will check whether it is
possible to add more laundry.
If
the è symbol goes out on the
■
display panel, it is possible to add
more laundry.
the è symbol lights up on the
■
display panel, it is not possible to
add more laundry.
To resume the program, press the A
button.The program will resume
automatically.
Notes
Do not leave the door open for too
■
long when adding more laundry as
water from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add more laundry during this time.
The load weight notification is not
■
active while more laundry is being
added.
en
35