Before Washing For The First Time - Bosch WAT Series Instruction Manual And Installation Instructions
Hide thumbs
Also See for WAT Series:
Table of Contents
Advertisement
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 13).
Never use a damaged machine.
■
Inform customer services.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the tap.
4.
Close the door (do not load any
5.
laundry).
Depending on the model, run the
6.
Drum Clean 90 °C or
Cottons 90 °C program.
Open the detergent drawer.
7.
Pour approximately 1 litre of water
8.
into compartment II.
Pour standard detergent into
9.
compartment II.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for wool or delicates.
Close the detergent drawer.
10.
Press the A button.
11.
When the program ends, switch off
12.
the appliance.
Your washing machine is now ready to
use.
Positioning and connecting
en
21
Advertisement
Table of Contents
