Programme default settings
en
Finished in-time
(ñ, Λήξη σε ñ)
Before starting the program, you can
preselect the program end time ("Ready
in" time) in hourly increments (h = hour),
up to a maximum of 24 hours.
To do this:
Select a program.
1.
The program duration will be
displayed for the selected program,
e.g. 2:30 (hours:minutes).
Press the Finished in-time button
2.
repeatedly until the required number
of hours is displayed.
Press the A button.
3.
The program will now start.
The selected number of hours (e.g. 8
h) is shown on the display panel and
counts down until the wash program
starts. The duration of the program
will then be displayed.
The program duration is
Note:
automatically adjusted when the
program is running.
Certain factors can affect the program
duration, e.g.:
Program settings,
■
Detergent dosage (additional rinse
■
cycles may be required due to
foaming),
Load size/type of fabrics (water
■
absorption differs),
Imbalances (e.g. due to fitted
■
sheets) are eliminated by rotating
the drum briefly several times,
Fluctuations in power supply,
■
Water pressure (inflow rate).
■
Once the program has been started,
you can change the preselected
number of hours as follows:
Press the A button.
1.
Use the Finished in-time button to
2.
change the number of hours.
Press the A button.
3.
30
Once the program has been started,
you can add more laundry or remove
laundry as required. ~ Page 35