Elaflex ZVA Slimline 2 GR Installation And Operating Information page 5

HINTS FOR PROPER HANDLING
A
INSERT THE SPOUT FULLY INTO THE TANK. The ball of the safety cut-out rolls forward
to open the air passage. This is the best way to fuel.
Make sure that the ZVA is hooked firmly into the fill pipe so that it cannot slip out
during refuelling.
B
With some near horizontal fill pipes version A is not possible. The safety cut-out attitude
valve prevents the valve from opening. The ball rolls backwards blocking the sensing path
and the nozzle trips off continuously.
C With situation B lift and hold the nozzle so that the ball rolls forward opening up the air
passage. Refuelling is now possible provided the nozzle is kept in this position.
D
DO NOT FILL TOO FAST: Splashing fuel can trip the nozzle before the tank is full.
Some filler necks are difficult to refuel. Reduce the flow rate to avoid blow backs. The
flow rate can be adapted to the capacity of the filler neck by the two - speed lever latch.
Upper position
Lower position
THE AUTOMATIC SHUT OFF WILL ALSO WORK IF THE LEVER IS HELD OPEN MANUALLY,
according to EN 13012. Once the fuel touches the sensing port (1) the automatic cuts off.
Topping up is possible.
A FEW DROPS OF FUEL WILL REMAIN IN THE AIR PASSAGE (2). Always tilt the nozzle
forward into the tank to drain for a few moments before returning it to the nozzle boot. Then the
next user will not be surprised by drips.
PLEASE NOTE
The ZVA Slimline 2 GR is approved for all standard gasoline fuels (also with ethanol content) in a
pressure range of 0,5 - 3,5 bar. The ZVA opens automatically when the pressure exceeds 6 bar.
If it is intended to use the nozzle for other applications you should consult your supplier who will
advise its suitability on receipt of full details, including fluid, and operating conditions.
GUARANTEE
We guarantee against defective materials and manufacturing up to 18 months from date of supply.
If the delivery date cannot be established, the date code on the nozzle (i.e.
prevails. Excluded are nozzles and parts subjected to wear and tear, abuse and to contamination.
Furthermore excluded are damages by misuse, indirect damages and costs, travelling related
to exchange and repair work. We refuse any liability for consequential loss or damage resulting
from the use of our nozzle.
2/2 = Fully opened for well vented, straight and near vertical fill pipes
1/2 = Reduced output for poorly vented pipes.
Description see page 16
st
·
2018 = 1 quarter 2018)
5