Table of Contents
Advertisement
Hardware Nomenclature
Refer to
— Figure 2
Suspended Ceiling
1.
Screws
2.
C-ring
3.
Existing support
4.
Support brackets
Refer to
— Figure 3
.
Nrill Safety Clip
1.
The cabinet and the grill both have a small loop of plastic line. The
grill's loop has a clip attached. Using the grill clip, attach the grill to
the cabinet's loop. This will help prevent the grill from falling should
it become detached.
Secondary Support Tab
2.
Loudspeakers can potentially generate substantial vibration. In
addition to ensuring all hardware is properly installed and secured,
you must use the secondary support tab on the enclosure to secure
the loudspeaker to an appropriate structural support. This will
minimize the chance of the loudspeaker falling from the ceiling
in the event the primary mount fails. Any cable or wire used as a
secondary support line must be strong enough to support several
times the weight of the loudspeaker. Do not use rope, string, twine
or other textile-based line in the secondary support system as it is
easily cut or burned. The secondary support attachment point and
any fasteners used on the building's structure must also be strong
enough to support several times the weight of the loudspeaker.
Refer to
— Figure 4
Connections
Connect signal wires either directly to ceramic terminal block noting correct polarity or to
the supplied plastic terminal block assembly. W hen using the plastic terminal assembly,
connect the four pin receptacle to the ceramic block observing polarity. Connect the signal
wires to the screw terminals of one of the two pin plugs observing correct polarity. The
other two pin plug can then be used as pass through to daisy chain the signal to another
speaker or it can be left unused.
TD-000264-00-E
1
1
From
Amplifier
– +
4
3
2
4
— Figure 2 —
— Figure 3 —
To Second
Loudspeaker
–
+
— Figure 4 —
2
Advertisement
Table of Contents
