Table of Contents
Advertisement
When the unit is wired to an appropriate control unit, movements along two axes are possible. "Pan" is a
horizontal change in camera direction, moving the field of view to the left or right. "Tilt" is a vertical change
in camera direction, raising or lowering the field of view.
1.
Apply power to the control unit (EVKEB-3000). The blue pilot light should illuminate.
2.
To pan or tilt camera, move the joystick up, down, left or right. The joystick control, when deflected
diagonally, will also drive the pan-and-tilt functions simultaneously.
3.
To set the EV3000D for preset operation and group touring operation. See appendix 1.
DIP SWITCH SETTING
Note
PROTOCOL
BAUDRATE
COM. DATA
Figure 4. Built-in Receiver Description
PIN
Description
Up to 16 Protocol Setting
4
PELCO-P, D Factory Set
Up to 4 Baud-rate Setting
2
2400, 4800, 9600, 19200 bps
Up to 4 Communication Port Setting
0: 1stop bit, no-parity
2
1: 1stop bit, odd-parity
2: 1stop bit, even-parity
3: not decided.
Advertisement
Table of Contents
