Assigning the Insight Watch to a Subject
6
8
10/19/2018 | Revision: 0
Note: To assign an activity monitor to an existing subject (such as in the case of a lost or broken device),
complete steps 1-4 above, and scroll to the bottom of the page. Select the corresponding subject
identifier from the list, then select "Assign Device to an Existing Subject. " Wait for the progress bar to
indicate that assignment is complete.
Remove the Insight Watch from the charging dock. Wait for the activity monitor to go from halt mode
into active mode, as indicated by the running man icon in the upper left corner of the screen. This takes
approximately 90 seconds. The Insight Watch is now collecting data and can be given to the subject.
(Continued)
Halt
Stop icon will be
displayed if the
Insight Watch is not
collecting data.
Active Mode
The Insight Watch is
collecting data.
actigraphcorp.com