Husqvarna K 535i Operator's Manual page 15

To connect coolant water
1. Connect the water hose to the water supply (A).
A
2. Turn the water tap (B) to let the water go or stop.
3. Examine if leakage occurs in the water connection or
the hose.
4. Make sure water pressure do not go by maximum
permitted water pressure, refer to
To start the product
1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. See
lockout on page 19 .
2. Put the battery in the battery holder.
3. Press on the lower part of the battery until you hear
a click sound. If the battery does not move into the
battery holder easily, it is not attached correctly into
the battery holder.
745 - 008 - 12.11.2018
B
Technical data .
4. Press and hold the start/stop button until the green
LED light comes on.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the blade speed and gives the
longest operation time from the battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out.
To stop the product
1. Press and hold the start/stop button on the keypad
until the green LED light goes out.
15