Advertisement
INSTRUCTIONS FOR
INSTALLATION AND OPERATION
MODEL V21 ODA-B DISTRIBUTION AMPLIFIER
This manual covers the installation, operation, and
maintenance of the Model V210DA-B Distribution Am-
plifier. This unit should be installed by a qualified
technician using approved materials and wiring prac-
tices in accordance with national, state, and local wiring
codes. Read these instruction through completely before
attempting installation.
The V210DA-B Distribution Amplifier provides a
maximum of six video outputs each equal to the single
video input to be used for operation of other video
equipment. Circuitry with individual and isolated com-
plementary transistor pairs provides power for several
WARNING: TO PREVENT RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
Product specifications subject to change without notice.
VICON INDUSTRIES INC. 89 ARKAY DRIVE, HAUPPAUGE, N.Y. 11788
TOLL FREE: l-800-645-91 16 . UK: 44/(O) 1489/577775
1. INTRODUCTION
VICON
FRONT PANEL
Figure 1
Front and Rear Panels
Characteristics include AC coupling (for operation with
both AC- and DC-coupled cameras), color compatibil-
ity, and a broad frequency response. The V210DA-B is
available in two input voltage configurations, 120 VAC
and 230 VAC (Model V210DA-B-230).
both models unless specifically stated otherwise.
Model V210DA-B is housed in a sturdy, heavy-gauge
steel chassis protected by a steel cover finished in gray
textured enamel.
POWER
TEL: 516-952-CCTV
l
. INFOFAX: 1-800-287-l 207
The term
Legend
1
CAMERA video input
outputs, 1-6
2
Video
3
Power cord
4 POWER push button
5
Power LED
part number 8006-8671-02-00
FAX: 516-951-CCTV
(2288)
l
Advertisement
Table of Contents
Related Manuals for Vicon V21 ODA-B
Summary of Contents for Vicon V21 ODA-B
- Page 1 WARNING: TO PREVENT RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. part number 8006-8671-02-00 Product specifications subject to change without notice. VICON INDUSTRIES INC. 89 ARKAY DRIVE, HAUPPAUGE, N.Y. 11788 TEL: 516-952-CCTV FAX: 516-951-CCTV (2288) TOLL FREE: l-800-645-91 16 .
-
Page 2: Important Safeguards
16. Overloading - Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock. 6. Attachments - Do not use attachments not recommended by Vicon as they may cause hazards. 17. Object and Liquid Entry - Never push objects of any kind into this video product through openings as they may touch dangerous volta 7. -
Page 3: Coaxial Cable Recommendations
Table B gives some equivalent insulation in applications subject to moisture. cable numbers of other manufacturers. Vicon recommends the following coaxial cable types, unless otherwise specified The shield must be copper braid providing 95% or better elsewhere in this manual. -
Page 4: Installation
2. INSTALLATION 2.1 Unpacking and Inspection All Vicon equipment is tested and inspected before leaving 2.1.2 INSPECTION FOR CONCEALED the factory. It is the carrier’s responsibility to deliver the DAMAGE equipment in the same condition as it left the factory. - Page 5 If an operating failure occurs in the system, inspect all If local troubleshooting is required, the unit may be cables and connections. Check the cameras to ensure that opened using the following procedure. it is functioning properly. Check each successive connec- tion for the presence of a good video signal.
- Page 6 C A M E R A Figure 3 System Connection Diagram, Branching System X671-697...
-
Page 7: Shipping Instructions
United Kingdom 4. Mark the R.A. number on the outside of the carton on the shipping label. Vicon and its logo are registered trademarks of Vicon Industries Inc. Copyright 0 1997 Vicon Industries Inc. All rights reserved. X671-697...
Need help?
Do you have a question about the V21 ODA-B and is the answer not in the manual?
Questions and answers