Lindy 38272 User Manual page 4

User Manual
Overview
Rear View
5V DC
1
Front View
1. 5V DC – Connect the provided power supply here
2. Video Inputs – Connect to source equipment, such as a PC or Notebook
3. HDMI Output – Connect to a HDMI equipped Display or Projector
4. IR Eye – IR receiver for the included IR Remote control
5. Status LED – Illuminates to show the active input device
6. Select – Toggle between the connected input devices
Installation & Operation
Installation is simple; connect the Presentation Switch to your source equipment using standard male to
male cable for each interface. If you're using 4K Ultra HD resolutions we recommend using a maximum
of 3m on the input of the Switch. The output can be directly connected to a HDMI Display or Projector
using a high quality cable of up to 10m in length, alternatively an active HDMI extension cable or HDMI
extender may be used to achieve longer distances.
Once all cables have been connected the switch can be used. Using the Auto-sensing feature the Switch
will automatically switch to the most recently connected input, perfect for switching between presenters
during a meeting.
Please Note: The supplied DisplayPort cable (or another all pins wired DisplayPort cable) must be used
for the automatic switching function to work correctly via the DisplayPort input. This cable must not be
connected to a DP Display as it may cause malfunction/damage.
Using the IR remote control you may directly switch between inputs, alternatively you may use the
following IR codes to integrate the Switch with an IR controller:
IR frequency: 38KHz
Custom Code: 40AF
Using the Select button on the front of the Switch will toggle the Input device from 1. VGA to 2.
DisplayPort to 3. HDMI and then back to 1. VGA.
VGA & Audio In
Input 1: VGA (1C)
Input 2: DisplayPort (0E)
Input 3 HDMI (01)
DP In HDMI In
2
HDMI DP VGA
4 5
English
HDMI Out
3
Select
6